2584248 - 1056B82 injection/ignition system e.c.u. (one) - r + r
Removing
(
Refitting
)
If the injection/ignition system control unit is replaced, run the following self-learning procedure. | Start up the engine without pressing the accelerator pedal with an engine temperature greater than or equal to 20 °C and idle the engine for 10 seconds |
- Disconnect the negative battery terminal.1. Disconnect electrical connections (1a), unscrew nuts (1b) and remove control unit (1c).
Refitting
(
Removing
)
- Fit the control unit in its seat and tighten the nuts to the recommended torque.
| Component | Fastening | dia | Value (daNm) | Validity |
|---|
| Injection/ignition system control unit | Nut | M6 | 0.7 ÷ 0.9 | 1.2 8v1.4 8v |
- Connect the electrical connections for the control unit.- Connect the negative battery terminal.
