2584174 - 1020D14 front crank shaft oil seal cover - r + r and replace seals for versions with oil pump on crank shaft, timing side
Removing
(
Refitting
)
Op. 0010T12 ENGINE OIL AND FILTER - REPLACE Op. 2110A60 MANUAL GEARBOX/ENGINE COUPLING BRACKET - R+R Op. 1020A20 CRANKCASE OIL SUMP - R + R CLEAN SEALS FOR SEALANT APPLICATION Op. 1084B28 ENGINE OIL INTAKE PUMP - R + R WITH CRANKCASE SUMP REMOVED Op. 1084B30 ENGINE OIL FILTER - R.R. Op. 1048A10 AIR FILTER ASSEMBLY - R.R. Op. 1032D26 TIMING SYSTEM FRONT PROTECTIVE COVER (UPPER PART) - R.R. Op. 1092B60 ALTERNATOR DRIVE BELT - R + R Op. 1092A10 CRANKSHAFT PULLEY - R + R Op. 1032D27 TIMING SYSTEM FRONT PROTECTIVE COVER (LOWER PART) - R.R. Op. 1008B10 FLEXIBLE MOUNTING FOR POWER UNIT FRONT SUPPORT (TIMING SIDE) - REPLACE Op. 1008A46 TIMING SIDE POWER UNIT RIGID SUPPORT -R.R. Op. 1056B82 INJECTION/IGNITION SYSTEM E.C.U. (ONE) - R + R Op. 1056B87 IGNITION/INJECTION SYSTEM CONTROL UNIT SUPPORT - R.R. Op. 5510C14 IGNITION COIL/S - R+R Op. 1016A20 SINGLE TAPPET COVER -R.R AND REPLACE GASKET Op. 1032B10 TOOTHED TIMING BELT - R + R FOR TIMING ADJUSTMENT OR REPLACEMENT Op. 1032B44 TOOTHED DRIVE PULLEY - R + R WITH TIMING BELT REMOVED1. Undo the bolt (1a) and remove the engine rpm sensor (1b).2. Disconnect the electrical connection for the minimum engine oil pressure switch.| Description | Connector | |
|---|---|---|
| 2 | Insufficient engine oil pressure sensor | See K030 ENGINE OIL PRESSURE SENSOR (SWITCH) |
Refitting
(
Removing
)
- Place the crankshaft front cover in its seat complete with gasket and tighten the bolts to the recommended torque.| Value daNm | Fastening | Component | dia | |
|---|---|---|---|---|
| - | 0.8 ÷ 1.0 | Bolt | Crankshaft oil seal front cover | M6 |