5530A14 ALTERNATOR - R+R FOR VERSIONS WITH AIR CONDITIONER - Fiat - DOBLO - eLearn

2584921 - 5530A14 alternator - r+r for versions with air conditioner

)

Follow the safety instructions Op. 5040 AIR CONDITIONING CASING AND COMPONENTS

- Position the vehicle on a lift.- Drain the coolant. Op. 0010T84 COOLANT FOR AIR CONDITIONING SYSTEM - DEHYDRATE AND RECHARGE Op. 4450B04 RIGHT FRONT WHEEL - R.R.Op. 7055B66 ENGINE COMPARTMENT DUST COVER IN RIGHT FRONT WHEEL ARCH - R.R. Op. 1092C11 POWER STEERING PUMP DRIVE BELT - R.R. FOR VERSIONS WITH AIR CONDITIONER Op. 1092G10 SINGLE ENGINE BELT - R.R.1. Undo the bolt (1a) and disconnect the connector (1b) for the pipe from the compressor (1c).(Operation required in order to unscrwe the upper alternator bolt (2a)).

Seal the connectors that have been disconnected using suitable plugs to prevent dampness and impurities from entering the system.

2. Unscrew upper bolt (2a) of alternator (2b).

- Raise the vehicle.1. Release and open the cover for the alternator electrical connections.2. Disconnect the electrical connections (2a) and (2b) for the alternator.

	Description	Connector
2a	ALTERNATOR	See A010 ALTERNATOR

3. Loosen the lower alternator retaining bolts.4. Remove the alternator.

Refitting ( Removing

) - Check that the alternator is not damaged.1. Position the alternator.2. Screw in the lower compressor fixing bolts and tighten them to the specified torque.

	Value daNm	Fastening	Component	dia
2	4.5 ÷ 5.5	Bolt	Alternator	M10x1.25

3. Connect the electrical connections (3a) and (3b) for the alternator and secure them using the nuts (3c).

	Value daNm	Fastening	Component	dia
-	0.7 ÷ 1.1	Nut	Alternator recharging lead	M8

	Value daNm	Fastening	Component	dia
-	0.3 ÷ 0.5	Nut	Warning light supply lead at alternator	M5

4. Close the cover for the electrical connections.

- Lower the vehicle.1. Screw in the upper alternator bolt and tighten to the recommended torque.

	Value daNm	Fastening	Component	dia
1	4.5 ÷ 5.5	Bolt	Alternator	M10x1.25

Replace the O rings for the connectors. Only use green coloured seals that are resistant to R134a coolant.Lubricate the connector threads using anti-freeze.

2. Connect the connector (2b) for the pipe to the compressor (2a) and secure it tightening the bolt (2c) to the recommended torque.

	Value daNm	Fastening	Component	dia
2c	0.5 ÷ 0.7	Bolt	Pipe connector on compressor	M6

Op. 1092G10 SINGLE ENGINE BELT - R.R. Op. 1092C11 POWER STEERING PUMP DRIVE BELT - R.R. FOR VERSIONS WITH AIR CONDITIONEROp. 7055B66 ENGINE COMPARTMENT DUST COVER IN RIGHT FRONT WHEEL ARCH - R.R. Op. 4450B04 RIGHT FRONT WHEEL - R.R.- Repressurize the coolant Op. 0010T84 COOLANT FOR AIR CONDITIONING SYSTEM - DEHYDRATE AND RECHARGE- Remove the vehicle from the lift.