2582353 - 7020C SLIDING SIDE DOOR

The side door is manufactured using conventional pressing processes and includes a sliding opening and closure system with three anchorage points. Passive safety is assured by side impact bars.The door is anchored and locked shut at the rear by means of a conventional central lock.An electrical contact device located at the lower front of the door ensures a contact for the door open indicator and door safety lock when the door is closed.The glazed door window includes two panes that slide over one another and are anchored in the middle to close.1, Lock2, Outer handle3, Interior door opening link4, Interior handle and safey device5, Door frame6, Door open limiter and lock7, Fixed window glass8, Sliding window glass9, Device for locking sliding glass open10, Door compartment seal11, Interior door panel12, Rear door pouch13, Lower seal14, Rear seal15, Exterior sliding door moulding16, Anchorage devices17, Sliding mount guides18, Safety pin19, Sliding door locating pins20, Upper guide cover

ADJUSTMENT

The right or left sliding side door (8) incorporates slots in anchorage points (1), (2), (6) and (7) for adjusting gaps and seal loads.At the top, upper device (1) and lower device (2) allow load on door compartment seal (5) to be increased or decreased. Before adjusting these devices, loosen locating pins (4) at the front.To increase the load on seal (5) at the rear of the door, adjust lock striker (3) secured to the pillar.Lower slide (7) allows vertical adjustment of the front part. Central slide (6) allows vertical adjustment of the rear part.

It is advisable to adjust only one device at a time and also to tighten the fastenings to the recommended torque before going on to the next adjustment.

1, Upper anchorage device2, Lower anchorage device3, Lock striker4, Locating pins5, Seal6, Rear anchorage device7, Lower anchorage device on the door8, Sliding side door