| | Results of the tests |
| 1 | REEL CHECK | All OK | Problems met | Operation |
|---|
| Check
that the reel is fitted correctly, checking that the reference pin
is correctly positioned in the bodyshell housing | Continue to Step 2 | Fitting irregular | Loosen the fixing bolt and
position the reference lug correctly Retighten the bolt to the recommended
torque |
| 2 | CHECK FOR PRESENCE OF FOREIGN BODIES | All OK | Problems met | Operation |
|---|
| Check
that there are no foreign bodies inside the system | Continue to Step 3 | Presence of foreign bodies | Remove foreign bodies |
| 3 | BELT CHECK | All OK | Problems met | Operation |
|---|
| Check
that there is no interference or distortion acused by accidents | Continue to Step 4 | There is interference
slowing down the sliding of the belts | Eliminate the interference, if necessary, replace
the damaged components |
| Presence of distortions on the front mounting rod | Replace the front rod Op. 7065A14 |
| Presence of distortion on the rear mounting rod | Replace the rear rod Op. 7065B14 |
| Presence of distortion on the front reel/pretensioner | Replace the front belt Op. 7065A10 |
| Presence of distortion on the rear reel | Replace the rear belt Op. 7065B10 |
| 4 | PRETENSIONER OPERATION CHECK | All OK | Problems met | Operation |
|---|
| Check
that the pretensioner has not been activated as the result of an
accident. If this is the case, there would be white powder on the
spring casing, the reel would be locked and/or the belt deteriorated | Continue to Step 5 | Evidence of pretensioner
activated | Replace the belt Op. 7065A10 |
| 5 | REEL RELEASE SYSTEM CHECK | All OK | Problems met | Operation |
|---|
| Check
the reel release, rewinding the belt for a brief section and gently
unwinding it | Continue to Step 6 | Front reel release system
faulty | Replace
the front belt Op. 7065A10 |
| Rear reel release system faulty | Replace the rear belt Op. 7065B10 |
| 6 | CORRECT COMPONENTS FITTING CHECK | All OK | Problems met | Operation |
|---|
| Check
that the right/left components are fitted on the correct side of
the vehicle | Continue to Step 7 | Fitting not correct | Restore the correct fitting
and, if necessary, replace the components |
| 7 | CHECK ON CORRECT OPERATION | All OK | Problems met | Operation |
|---|
| Check
that the fault is no longer present | | Fault persists | Search for the fault starting from another symptom' |