1032B10 TOOTHED TIMING BELT - R + R FOR TIMING ADJUSTMENT OR REPLACEMENT - Fiat - DOBLO - eLearn

2584193 - 1032B10 toothed timing belt - r + r for timing adjustment or replacement

) Position the vehicle on a lift.Proceed with the removal Op. 4450B04 RIGHT FRONT WHEEL - R.R..Proceed with the removal Op. 1092G10 SINGLE ENGINE BELT - R.R..Proceed with the removal Op. 1092A10 CRANKSHAFT PULLEY - R + R.Proceed with the removal Op. 1008a46 TIMING SIDE POWER UNIT RIGID SUPPORT - R.R..Proceed with the removal Op. 1032D12 TIMING SYSTEM PROTECTIVE COVER(S) - R + R.1. Adjust the bolt fixing the drive pulley and rotate the crankshaft until the timing references are aligned (cylinder 1 at T.D.C.).

1. Check that the timing system drive pulley dowel is facing downwards.2. Loosen nut (2a) of the timing system mobile tensioner and remove toothed timing belt (2b).

Refitting ( Removing

) 1. Undo the bolt fixing the crankcase front cover shown in the diagram.Temporarily fit the toothed timing drive belt on the drive pulley.2. Fit the tool (2a) and fasten it using the calibrated screw (2b).

The crankshaft must be rotated, using small movements, to allow the locating dowel on the timing drive pulley to be inserted in the opening in the tool.

	Description	Code
2a	Template	1.860.905.000

	Description	Code
2b	Calibrated screw	1.860.905.010

1. Check that the timing references are aligned.2. Fully fit the toothed timing drive belt.

1. Apply a screwdriver in the opening (1a) for leverage until the reference for the tensioner (1b) corresponds with the reference opening (1c) and tighten the moving tensioner nut (1d) to the recommended torque in this position.

	Fastening	Component	dia	Value(daNm)
1d	Nut	MOBILE TIMING TENSIONER	M8	2.3 ÷ 2.8

Remove the tools.

	Description	Code
-	Template	1.860.905.000

	Description	Code
-	Calibrated screw	1.860.905.010

Tighten the bolt fixing the front cover removed previously.

Rotate the crankshaft through two revolutions.Check once again that the timing references and the tensioning reference on the moving tensioner correspond.Proceed with the refitting Op. 1032D12 TIMING SYSTEM PROTECTIVE COVER(S) - R + R.Proceed with the refitting Op. 1008a46 TIMING SIDE POWER UNIT RIGID SUPPORT - R.R..Proceed with the refitting Op. 1092A10 CRANKSHAFT PULLEY - R + R.Proceed with the refitting Op. 1092G10 SINGLE ENGINE BELT - R.R..Proceed with the refitting Op. 4450B04 RIGHT FRONT WHEEL - R.R..Remove the vehicle from the lift.