The activation of the dipped headlamps is controlled by an earth signal coming from the steering column switch unit H05 , by turning the ring nut, and reaches the body computer M01 at pin 4 connector D.With the ignition key in the OFF position, the signal reaches pin 33 connector F of the body computer from the steering column switch unit to activate the follow me home funciton.To switch the dipped headlamps on, the body computer M01 energizes a relay R1 in the junction unit under the dashboard B02 which receives a direct supply, protected by fuse F1 , housed in the engine compartment junction unit B01 , and sends it to the left and right headlamps.Each line is protected by a fuse in the junction unit under the dashboard B02 : F13 for the left headlamp, F12 for the right headlamp.Another supply signal ''controlled by the ignition'' (INT), coming from the ignition switch H01 arrives via pin 11 connector E of the junction unit under the dashboard B02 .The direct signal to the left headlamp is also sent to the instrument panel E50 at pin 7 connector A for the functions that require this enablement signal. In addition, the instrument panel E50 communicates with the body computer M01 via pins 8 and 9 connector A and receives supply lines at pins 1 and 3 connector A. It then receives the earth signal at pin 2 connector A.Both the left and right headlamp signals are used to operate the headlamp alignment See E3080 HEADLAMP AGLINMENT CORRECTOR.