2584610 - 2710A32 intermediate drive shaft bearing support - r + r with intermediate drive shaft removed

Removing ( Refitting ) Ensure that the ignition key is in the stop position, then disconnect the battery negative terminal.

	Name	Connector
-	Battery	See A1B BATTERY ( BATTERY POSITIVE )

Proceed with removal    Op. 7055B54 PROTECTION/GUARD UNDER ENGINE - R.R.Proceed with removal1. Disconnect the electrical connections from the alternator.    Op. 1092G10 SINGLE ENGINE BELT - R.R.

	Name	Connector
1	Alternator	See A010 ALTERNATOR

1. Undo the bolt (1a) and remove the electrical wiring mounting bracket (1b) from the intermediate shaft support. 1. Undo the upper alternator fixing bolt. 1. Undo bolts (1a) and remove the upper alternator mounting bracket (1b). 1. Loosen the lower alternator fixing bolt, then partly release the bolt. 1. Undo the bolts (1a) and remove the intermediate driveshaft mounting (1b). Refitting ( Removing ) 1. Place the intermediate driveshaft support (1a) back in its housnig and fix it tightening the bolts (1b) to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
1b	Bolt	FRONT DRIVE SHAFT BEARING MOUNT	M10	(Crankcase side) 4.5 ÷ 5.5

Completely fit the lower alternator fixing bolt and screw in the nut but do not fully tighten it.Place the upper alternator mounting bracket back in its housing and fix it using the bolts.Tighten the bolts fixing the alternator to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	ALTERNATOR ASSEMBLY	M10	(Support side) 4.5 ÷ 5.5

	Fastening	Component	Ø	Value(daNm)
-	Bolt	ALTERNATOR ASSEMBLY	M12	(Support side) 6.3 ÷ 7.7

Connect the electrical connections to the alternator.Place the electrical wiring mounting bracket in its housing on the intermediate shaft support and secure it using the bolt.Proceed with refitting    Op. 1092G10 SINGLE ENGINE BELT - R.R.Proceed with refittingConnect the negative (-) battery terminal    Op. 7055B54 PROTECTION/GUARD UNDER ENGINE - R.R.