2584614 - 2710A52 differential end sliding joint (one) l/h or r/h - r + r with drive shaft removed - includes boot replacement

Removing ( Refitting ) Place the drive shaft in a vice.1. Remove the circlip (1a) and withdraw the tripod joint from the drive shaft (1b).2. Remove retaining clip (2a) and move back protective gaiter (2b). 1. Remove the fluid-tight bearing from the drive shaft using a universal puller.2. Remove the protective gaiter from the drive shaft.

The fluid-tight bearing and protective gaiter are supplied as a single part. Whenever the protective boot is replaced, it is therefore also necessary to replace the fluid-tight bearing.

Refitting ( Removing ) Replace the gaiter and the fluid-tight bearing.Position the gaiter - fluid-tight bearing assembly on the drive shaft. 1. If the right fluid-tight gaiter - bearing assembly has been serviced, it must be refitted in accordance with the specified dimensions.Dimension for fitting right drive shaft fluid-tight gaiter-bearing assembly.

	Measurement		Value
1	Fitting of right driveshaft roller bearing (mm)		103.3

Dimension for fitting right drive shaft ball bearing - gaiter assembly.

	Measurement		Value
1	Fitting of right driveshaft ball bearing (mm)		104.4

2. If the left fluid-tight gaiter- bearing assembly has been removed, it must be refitted in accordance with the specified dimensions.Dimension for fitting left drive shaft fluid-tight gaiter-bearing assembly.

	Measurement		Value
1	Fitting of left driveshaft roller bearing (mm)		143.3

Dimension for fitting left drive shaft ball bearing - gaiter assembly.

	Measurement		Value
1	Fitting of left driveshaft ball bearing (mm)		144.4