1028H14 PISTON CONNECTING ROD SET - R R - Fiat - DOBLO - eLearn

2585291 - 1028H14 piston connecting rod set - r r

) Op. 1020A24 CRANKCASE OIL SUMP - R + R CLEAN SEALS FOR SEALANT APPLICATION WITH ENGINE REMOVED1. Undo the retaining bolts.2. Remove the engine oil pump (2a) complete with oil suction device (2b).Keep the oil pump gasket.3. Undo the fixing bolt (3a) and remove the section inside the crankcase (3b) for the engine oil dipstick.

1. Use service bolts (1a) to fit the tool (1b) used to rotate the crankshaft.

	Description	Code
1b	Flange	1.860.815.000

1. Undo the fixing bolts (1a) and remove the connecting rod cap (1b).2. Remove the lower connecting rod half-bearing.3. Remove the connecting rod-piston assembly.4. Remove the upper connecting rod half-bearing.

Refitting ( Removing

) Turn the crankshaft using the tool fitted previously.1. The connecting rod-piston assemblies are fitted with the engine rotation arrow (1a) stamped on the piston crown pointing towards the inlet side.2. Check that the stamp on the cylinder bore/liner to which the connecting rod belongs is on the exhaust side.

1. Fit the connecting rod-piston assembly (1a) with half-bearing using the tool (1b) to compress the piston rings and then fit the piston into the bore/liner.

	Description	Code
-	Fitting tool	1.860.700.000

Fit the crankpin caps.Tighten the nuts fixing the connecting rod caps to torque.

	Fastening	Component	dia	Value(daNm)
-	Nut	CONNECTING ROD CAP FASTENERS	M9	5.1

Remove the tool for rotating the crankshaft.

	Description	Code
-	Flange	1.860.815.000

Fit the crankcase internal section for the engine oil dipstick.Position a new oil pump gasket.Fit the oil pump tightening the fixing bolts to torque.

	Fastening	Component	dia	Value(daNm)
-	Bolt	ENGINE OIL PUMP	M6	2.5

Op. 1020A24 CRANKCASE OIL SUMP - R + R CLEAN SEALS FOR SEALANT APPLICATION WITH ENGINE REMOVED