2585286 - 1016E14 single cylinder head valve guides - replace during operation 1016e10

Removing ( Refitting ) 1. Remove the valve guides (1b) using the drift (1a).

	Description	Code
1a	Drift	1.860.395.000

Refitting ( Removing ) Measure the valve guide bore checking that it is within the recommended values.

	Measurement		Value
-	Valve guide bore diameter in cylinder head (mm)		12.950 - 12.977

If necessary, ream the valve seat.Check the measurement of the new valve guide.Make a note of the measurement of the valve seat after reaming.Valve guides are available as spares with the following diameters and oversizes.

	Measurement		Value
-	Valve guide outer diameter (mm)	Inlet	13.010
Exhaust	13.030

	Measurement		Value
-	Oversizes (mm)		00.5 / 0.10 / 0.25

Also bear in mind that the clearance between the valve guides and the bore in the cylinder head should be within the recommended values.

	Measurement		Value
-	Clearance between valve guide - bore in cylinder head (mm)		0.033 - 0.080

Before fitting the new valve guides the cylinder head must be heated to a temperature of around 80° -100 °.1. Fit the new valve guide using an appropriate drift.

	Description	Code
1	Counter-torque	1.860.846.000

Ream the valve guide inner diameter using a suitable reamer.Check that the inner diameter of the valve guide and the clearance after refacing between it and the valve are within specified values, otherwise replace the valve guide.

	Measurement		Value
-	Valve guide inner diameter (mm)		7.022 ÷ 7.040

	Measurement		Value
-	Inlet valve - inlet valve guide clearance (mm)		0.022 ÷ 0.058

	Measurement		Value
-	Exhaust valve - exhaust valve guide clearance (mm)		0.030 ÷ 0.066