2585405 - Introduction - AXLE
Drive shafts with constant velocity joints at the wheel end and tripod joints at the differential end make up a transmission assembly that transmits motion from the gearbox to the drive wheels.DRIVESHAFTS
The power is transmitted through driveshafts with wheel side constant velocity joints and gearbox side three-lobe joints.In order to keep oil leaks to a minimum, there are sealed ball bearings (2) on the gearbox side boots, fitted on the actual driveshafts.There is a seal (2) which is an integral part of the bearing (1).The bearing and gaiter are replaced as one unit during service.The right drive shaft comes with a hot press-fitted vibration damping mass that must never be removed. It is advisable to check that the position is correct at intervals and replace the whole drive shaft if necessary.