2584886 - 5505B41 wiring built into load compartment right rear door flap r r with interfering parts removed
Removing
(
Refitting
)
1. Disconnect the electrical connectors (1a) and (1b).| Name | Connector | |
|---|---|---|
| 1a | Tailgate rear seal/ | See D085 TAILGATE/REAR SEAL |
| Name | Connector | |
|---|---|---|
| 1b | Right heated rear windscreen | See P53 RIGHT HEATED REAR WINDSCREEN ( RIGHT DOOR ) |
 | Before removing the electrical wiring from the housing it is advisable to connect a general sensor to each individual connector so that they retrace the route of the section of wiring removed. When refitting, this operation makes it possible to renew the correct route of the cable removed. |
Refitting
(
Removing
)
Check that the wiring is not damaged.If necessary, check the continuity.Connect each individual electrical connector to the sensor used previously in order to facilitate the routing of the section of wiring removed in its original position.Pull the end of the sensor and restore the routing of the electrical wiring.Carry out the same operation for all the electrical connectors.Position the electrical wiring, securing it using new retaining bands.Disconnect each individual connector from the sensor.Connect the electrical connectors: | Name | Connector |
|---|---|---|
| 1a | Tailgate rear seal/ | See D085 TAILGATE/REAR SEAL |
| Name | Connector |
|---|---|---|
| 1b | Right heated rear windscreen | See P53 RIGHT HEATED REAR WINDSCREEN ( RIGHT DOOR ) |