2584226 - 1040A70 submerged pump assembly complete with level guage control - r + r

Removing ( Refitting ) Disconnect the battery negative terminal.1. Acting on the levers (1a), lift up the rear seat cushion (1b) and move the floor covering (1c) aside to gain access to the fuel pump flap (1d).
1. Undo the fixing bolts (1a) and remove the protective cover (1b).2. Disconnect the electrical connection from the level gauge.

NameConnector
2Fuel pump and sender unit    See N040 FUEL PUMP AND LEVEL GAUGE
3. Disconnect the rapid attachment for the supply pipe.4. Using the tool (4a), undo the ring nut (4b), then remove the fuel pump (4c) complete with gauge.

NameCountry
4aTool. for removing. fuel pump retaining ring nut1.854.033.000
Refitting ( Removing ) Place the fuel pump in the special housing in the tank.Fit the lock-nut and use the tool to tighten to torque.

NameCountry
-Tool. for removing. fuel pump retaining ring nut1.854.033.000

FasteningComponentØValue(daNm)
-Ring nutSUBMERGED FUEL PUMP RING NUT-0.6
Replace the gasket under the fuel pump and take care, when refitting, to check that the gasket is correctly positioned in order to ensure the seal.
Connect the rapid attachment for the fuel supply pipe.Connect the fuel pump and level gauge electrical connection.

NameConnector
-Fuel pump and sender unit    See N040 FUEL PUMP AND LEVEL GAUGE
Tighten the fuel pump protective cover retaining bolts.Refit the floor covering.Lower the rear seat cushion.Connect the battery negative terminal.