1092C11 POWER STEERING PUMP DRIVE BELT - R R FOR VERSIONS WITH AIR CONDITIONER - Fiat - DOBLO - eLearn

2584328 - 1092C11 power steering pump drive belt - r r for versions with air conditioner

) Position the vehicle on a lift.Raise the vehicle. Op. 7055B54 PROTECTION/GUARD UNDER ENGINE - R.R.1. Loosen the connector for the power assisted steering fluid pump pipe to gain access to the belt shield bolt.2. Undo the fixing bolts (2a) and remove the belt shield (2b) from the pump.

1. Loosen the front bolts (1a) and the rear bolts (1b) fixing the power assisted steering pump to the mounting and also loosen the micrometric screw (1c) for the belt tensioning device.2. Remove the drive belt from the crankshaft pulley and from the power assisted steering pump pulley.

Refitting ( Removing

)

Check belt condition. In particular, check for tears, cracks, surface wear and dry or hard parts that could lead to loss of grip. Change the belt if one of these defects is noted.

Fit the new power assisted steering pump drive belt on the respective pullies.Acting on the micrometric screw, tension the belt, then lock the front and rear fixing bolts.1. Using tool (1a) check the belt tension (1b) is within recommended values.

	Name	Country
1a	Torque wrench	1.895.762.000

	Measurement		Value
-	Tension (daN)		36 ÷ 45
	New belt (-)	-

	Measurement		Value
-	Tension (daN)		23 ÷ 30
	Used belt (-)	-

If the value measured is within the recommended limits, tighten the bolts fixing the pump to the mountings to torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	POWER STEERING PUMP	M10 x 1.25	(Slot) 5

	Fastening	Component	Ø	Value(daNm)
-	Bolt	POWER STEERING PUMP	M10 x 1.25	(Fulcrum) 5

Fit the belt shield and secure it using the fixing bolts.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	POWER STEERING PUMP GUARD	M6	0.7

Tighten the power assisted steering pump connector to torque.

	Fastening	Component	Ø	Value(daNm)
-	Connector	PIPE BTWN PUMP + POWER STEERING BOX	M16 x 1.5	(Power assisted steering pump side) 4

If the reading is not within recommended limits, repeat the tightening operation. Op. 7055B54 PROTECTION/GUARD UNDER ENGINE - R.R.Remove the car from the lift.