2584746 - 4410D14 front suspension crossbeam - r+r with wishbones removed

Removing ( Refitting ) 1. Remove the nuts securing the first section of the exhaust pipe to the rear section.2. Undo the bolt securing the exhaust pipe flexible block support bracket.3. Disconnect the flexible block supporting the rear section of the exhaust pipe.4. Lower the rear section of the exhaust pipe and secure to the car using a rope. 1. Loosen nut (1a) and unscrew bolt (1b) securing the central reaction link.2. Turn the central link so that it is outside the working area.3. Undo the bolts securing the power assisted steering box to the front beam. Prepare a hydraulic jack under the front beam.1. Undo the side bolts securing the beam to the body.2. Lower the hydraulic jack and remove the front beam. Refitting ( Removing ) .

Ensure that the worm screws for securing the suspenion to the body are free of wax oil and impurities.

Position the beam on the hydraulic column jack. Position the beam on the hydraulic column jack.Raise the jack and offer the crossmember up to the attachments on the bodyshell.Screw in the side bolts securing the beam to the body and tighten (firstly position the fastening on the timing side).

	Fastening	Component	Ø	Value(daNm)
-	-	-	-	-

Secure the steering box to the front beam and tighten the retaining bolts.

	Fastening	Component	Ø	Value(daNm)
-	Nut	POWER STEERING BOX	M12 x 1.25	8.8

Refit the central power unit link and tighten the central botl and retaining nut to torque.

	Fastening	Component	Ø	Value(daNm)
-	Nut	REACTION ROD	M12 x 1.25	8

	Fastening	Component	Ø	Value(daNm)
-	Bolt	REACTION ROD	M12 x 1.25	12

Fasten the rear exhasut pipe section to the flexible block.Connect the first exhaust pipe section.Secure the first exhaust pipe section to the support bracket on the front beam.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	EXHAUST PIPE MOUNTS/FASTENERS	M8	(on crossmember) 2.8