2584174 - 1020D14 front crank shaft oil seal cover - r + r and replace seals for versions with oil pump on crank shaft, timing side

Removing ( Refitting ) Position the vehicle on a lift.    Op. 7055B54 PROTECTION/GUARD UNDER ENGINE - R.R.    Op. 1048A10 AIR FILTER ASSEMBLY - R.R.    Op. 1032D12 TIMING SYSTEM PROTECTIVE COVER(S) - R + R    Op. 4450B04 RIGHT FRONT WHEEL - R.R.    Op. 1092B60 ALTERNATOR DRIVE BELT - R + R    Op. 1092A10 CRANKSHAFT PULLEY - R + R    Op. 1032B10 TOOTHED TIMING BELT - R + R FOR TIMING ADJUSTMENT OR REPLACEMENT    Op. 2110A60 MANUAL GEARBOX/ENGINE COUPLING BRACKET - R+R    Op. 1032B44 TOOTHED DRIVE PULLEY - R + R WITH TIMING BELT REMOVED    Op. 1020A30 ENGINE OIL DRAIN PLUG - REPLACE    Op. 1020A20 CRANKCASE OIL SUMP - R + R CLEAN SEALS FOR SEALANT APPLICATION    Op. 1084B28 ENGINE OIL INTAKE PUMP - R + R WITH CRANKCASE SUMP REMOVED    Op. 1088C14 WATER PUMP - R + R WITH DRIVE BELT(S) REMOVED1. Connect the electrical connection for the engine oil pressure switch.

	Description	Connector
1	Insufficient engine oil pressure sensor (switch)	See K030 ENGINE OIL PRESSURE SENSOR (SWITCH)

2. Undo and remove the engine oil filter. 1. Undo the fixing bolts (1a) and remove the front oil pump casing cover (1b). Refitting ( Removing ) Fit the front crankcase cover on the cylinder block/crankcase.

Whenever the front crankcase cover is removed, the underlying gasket must be changed.

Tighten the bolts fixing the front cover to torque.

	Fastening	Component	dia	Value(daNm)
-	Bolt	FRONT COVER CRANKSHAFT	M6	(Cylinder block/crankcase) 1

Tighten the oil filter by hand.Connect the electrical connection for the engine oil pressure switch.

	Description	Connector
-	Insufficient engine oil pressure sensor (switch)	See K030 ENGINE OIL PRESSURE SENSOR (SWITCH)

    Op. 1088C14 WATER PUMP - R + R WITH DRIVE BELT(S) REMOVED    Op. 1084B28 ENGINE OIL INTAKE PUMP - R + R WITH CRANKCASE SUMP REMOVED    Op. 1020A20 CRANKCASE OIL SUMP - R + R CLEAN SEALS FOR SEALANT APPLICATION    Op. 1020A30 ENGINE OIL DRAIN PLUG - REPLACE    Op. 1032B44 TOOTHED DRIVE PULLEY - R + R WITH TIMING BELT REMOVED    Op. 2110A60 MANUAL GEARBOX/ENGINE COUPLING BRACKET - R+R    Op. 1032B10 TOOTHED TIMING BELT - R + R FOR TIMING ADJUSTMENT OR REPLACEMENT    Op. 1092A10 CRANKSHAFT PULLEY - R + R    Op. 1092B60 ALTERNATOR DRIVE BELT - R + R    Op. 4450B04 RIGHT FRONT WHEEL - R.R.    Op. 1048A10 AIR FILTER ASSEMBLY - R.R.    Op. 0010T11 ENGINE OIL - CHECK LEVEL AND TOP UP    Op. 7055B54 PROTECTION/GUARD UNDER ENGINE - R.R.Remove the vehicle from the lift.