4410B64 TRACK ROD END (ONE) ON FRONT STEERING KNUCKLE, LEFT OR RIGHT - REPLACE. - Fiat - DOBLO - eLearn

2584740 - 4410B64 TRACK ROD END (ONE) ON FRONT STEERING KNUCKLE, LEFT OR RIGHT - REPLACE.

) Place the car on a lift.Remove a front wheel, proceed as in the example Op. 4450B02 LEFT FRONT WHEEL - R.R..Raise the vehicle.1. Strike the upper part of the rivets securing the ball joint.2. Destroy the rivetting using a drill, firstly with a small bit and then with a 10 mm bit.

The 10 mm bit is used only to destroy the head of the rivets securing the ball joint. Take care not to damage the wishbone.

Remove any burrs using a drift.

1. Undo the nut securing the wishbone ball joint to the front hub steering knuckle.2. Separate the wishbone ball joint (2a) from the steering knucle using tools (2b) and (2c).

	Name	Country
2b	Head extractor	1.847.035.000

	Name	Country
2c	Tool for extracting steering knuckles	1.847.035.001

Remove the nut securing the ball joint to the steering knuckle.

1. Remove the ball joint from its seat on the wishbone using tools (1a) and (1b) and reaction bar (1c).

	Name	Country
1a	Extractor	1.840.005.001

	Name	Country
1b	Clamps	1.840.005.303

	Name	Country
1c	Pad	1.845.028.000

Refitting ( Removing

) Position a new ball joint on the wishbone.Secure the ball joint to the wishbone using the three bolts supplied with the ball joint.Tighten the bolts securing the ball joint to torque.

	Fastening	Component	Ø	Value(daNm)
-	Nut	FRONT SUSPENSION LOWER LEVER BALL JOINT	-	(on track control arm) 2.4

Fit the head (conical) to the pillar and tighten the retaining nut.

	Fastening	Component	Ø	Value(daNm)
-	Nut	FRONT SUSPENSION LOWER LEVER BALL JOINT	M12 x 1.25	(on pillar) 6

Refit the front wheel, proceed as in the example Op. 4450B02 LEFT FRONT WHEEL - R.R.Remove the car from the lift.