2584767 - 4450A40 rear wheel geometry - check using optical equipment

The rear wheel geometry should be checked after having subjected the components which affect the wheel geometry to the following checks:tyre inflation pressure;the eccentricity and the orthogonality of the wheel rims should not exceed 3 mm;wheel bearing end float;

Toe in check:The rear suspension consists of a rigid axle and two leaf springs at right angles to the actual axle therefore the toe in cannot be adjusted. If the value measured is not within the recommended limits, check the axle and the bodyshell.

Carry out the preliminary checks on the vehicle and remove any loads transported.Position the vehicle (in running order) on the lift with test equipment.1. Check that the toe in (1a-1b) is within the recommended limits.The toe in figures refer to standard A vehicles = unladen vehicle including spare wheel, tools, accessories and supplies (full fuel tank).

	Measurement		Value
-	Rear wheel toe in (mm)		0 ± 1
	Standard A (-)	-

Camber check:The rear wheel camber cannot be adjusted. If the value is not within the recommended limits, check the axle and the bodyshell.

Carry out the preliminary checks on the vehicle and remove any loads transported.Position the vehicle (in running order) on the lift with test equipment.1. Check that the rear wheel camber is within the recommended limits.The camber figures refer to standard A vehicles = unladen vehicle including spare wheel, tools, accessories and supplies (full fuel tank).

	Measurement		Value
-	Rear wheel camber (Gradi)		0 ± 1
	Standard A (-)	-