2585275 - 7210L56 R.R. REAR WING opposite sliding door
Removing ( Refitting ) Check if any of the connected parts are deformed by checking body alignment dimensions. Use appropriate measurement tools (reference rigs, templates or gauges). Straighten the body if necessary.1. Use a pneumatic saw to cut along the cutting lines shown around the edge of the rear wing.2. Cut around the edge of the fuel filler compartment.Use a chamfering machine and drill to reduce weld spots around the edges of the trim and along the area of contact wtih the underlying frame.Disconnect the trim from the underlying sealant positioned along the window compartment area.3. Remove the rear wing
1. Use a pneumatic saw to trim the rear wing panels cut edges along
the joint with the roof trim.2. Use a chamfering machine to reduce the weld spots along the joint
between the roof and underlying rear wing cut edge.3. Use a suitable chisel (3a) to raise roof trim (3b) off wing trim
cut edge (3c) so that the part can be positioned.
Straighten the edges of the
panel.Use a grinding wheel to remove the weld
spot residues.Remove sealant residues from along the
window housing areas and underlying reinforcement bracket.Apply electro-galvanizing paint to the
parts which have been ground.
Refitting
(
Removing
)
1. Trace a cutting line along the upper part of the replacement
part and use a pneumatic saw to remove about 1 cm from the upper
panel edge.This operation is necessary to ensure the
part can be fitted and welded with ease in the area of the joint
with the roof without creating additional thickness if the cut edge
is deliberately left. 2. Use a rotary brush to remove the corrosion-proofing around the
edge of the parts.3. Apply electro-galvanizing paint to the edges in contact with
the vehicle.
Apply a new layer of sealant
along the areas of contact with the window compartments and the
underlying reinforcement bracket.1. Correctly position the replacement part (1a) on the bodyshell
and secure it using self-locking clamps (1b).Check the part and cut edge are perfectly
aligned and joined in the upper area of the joint with the roof.
1. Spot weld along the areas shown in the diagram.2. Fill weld (rivet) the remaining areas of contact between part
and body shown in the figure.
Level the spot welds using
a grinding wheel and apply galvanised finish to the ground areas.Check that the welded parts are correctly
positioned.Level the spot welds using a disc grinder.Use a rotary brush to clean the inner parts.Apply electro-galvanizing paint to the
parts which have been ground.
When the work is completed, refit the elements removed previously. |