244000499 - K062 ABS AND HANDBRAKE WARNING LIGHTS BOTH ON

With the ignition, the ABS warning light and the handbrake warning light come on simultaneously and stay on for longer than 3 seconds (both warning lights should go off after the initial control unit test)

The low brake fluid level and handbrake warning light also indicates an EBD fault if it comes on at the same time as the ABS warning light

Under these circumstances, the rear wheels may lock and the vehicle may skid if the brakes are operated because the system EBD function is temporarily deactivated. If it comes on by itself, this means that the handbrake is on or the brake fluid level is too low

1	CHECK USING DIAGNOSTIC EQUIPMENT	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Connect the diagnostic test equipment (Examiner or other instruments) to the tester input.Check that there are no faults in the ABS control unit.	Move on to Step 2	1. Error detected in the control unit	1. Continue following the instructions for the diagnostic equipment
			2. No communication with the control unit	2. Restore the connection between the ABS control unit and the diagnostic connector
2	CHECK ON CORRECT OPERATION	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check that the fault is no longer present	End of diagnosis