2710A10 DRIVE SHAFT WITH JOINTS (ONE), L/H OR R/H - R + R - Fiat - DUCATO - eLearn

244001059 - 2710A10 DRIVE SHAFT WITH JOINTS (ONE), L/H OR R/H - R + R

) Op. 7055B54 UNDER-ENGINE GUARD - R R Op. 4450B10 TYRE INFLATION VALVE CAP - REPLACEPosition a column hydraulic lift under the track control arm in order to work safely. 1. Undo the fixing bolts (1a) and remove the left brake caliper-bracket assembly (1b) from the brake disc without disconnect the fluid pipes.

1. Undo the nut fixing the track rod end to the steering knuckle.2. Extract the track rod end (2b) from the housing in the steering knuckle using the tool (2a).

	Description	Code	Function
2a	Head extractor	1.847.038.000	Ball joint removal

3. Undo the bolts fixing the steering knuckle to the shock absorber.4. Using a hammer and chisel, remove the staking from the nut securing the wheel hub to the driveshaft and then undo it.

1. Break the band (1a) securing the differential internal driveshaft and remove the right driveshaft (1b).

Refitting ( Removing

) Position the driveshaft in the housing on the vehicle.Connect the driveshaft to the differential internal driveshaft.

Make sure that there is the correct amount of grease inside the boot and the differential internal driveshaft.

1. Fit and new boot and band (1a) securing it to the differential internal driveshaft using the tool (1b).

	Description	Code	Function
1b	Caliper	1.870.857.000	Constant velocity joint gaiter installation

Fit the constant velocity joint in the wheel hub.Tighten the bolts fixing the steering knuckle to the shock absorber to torque.

	Value - daNm	Fastening	Component	Ø
.	19	Bolt	FRONT HUB STRUT	M16

1. Use a hammer and chisel to stake the wheel hub drive shaft retaining nut as shown in the figure.The figure below refers to the 1500 kg version.

	Value - daNm	Fastening	Component	Ø
.	37	Nut	FRONT HUBS COMPLETE WITH BEARING	M28

The figure below refers to the 1800 kg version.

	Value - daNm	Fastening	Component	Ø
.	42	Nut	FRONT HUBS COMPLETE WITH BEARING	M33

Tighten the bolts fixing the steering knuckle to the shock absorber to torque.

	Value - daNm	Fastening	Component	Ø
.	19	Bolt	FRONT HUB STRUT	M16

Tighten the nut fixing the ball joint to the steering rod to torque.

	Value - daNm	Fastening	Component	Ø
.	6.9	Nut	ADJUSTABLE LINK BALL JOINTS	M16

Fit the brake caliper - bracket assembly and tighten the bolts fixing the bracket to the left disc to torque.

	Value - daNm	Fastening	Component	Ø
.	21	Bolt	FRONT BRAKE CALIPER BRACKET	M16

Op. 4450B10 TYRE INFLATION VALVE CAP - REPLACE Op. 7055B54 UNDER-ENGINE GUARD - R R