244001060 - 2710A12 DRIVE SHAFT COMPLETE WITH JOINTS (ONE), L/H OR R/H - R + R WITH DIFFERENTIAL END JOINT OR WHEEL END JOINT DISCONNECTED

Removing ( Refitting ) Position a column hydraulic lift under the track control arm in order to work safely.1. Undo the fixing bolts (1a) and remove the left brake caliper-bracket assembly (1b) from the brake disc without disconnect the fluid pipes.
1. Undo the nut fixing the track rod end to the steering knuckle.2. Extract the track rod end (2b) from the housing in the steering knuckle using the tool (2a).
DescriptionCodeFunction
2aHead extractor1.847.038.000Ball joint removal
3. Undo the bolts fixing the steering knuckle to the shock absorber.
1. Break the band (1a) securing the differential internal driveshaft and remove the right driveshaft (1b).
Refitting ( Removing ) Position the driveshaft in the housing on the vehicle.Connect the driveshaft to the differential internal driveshaft.
Make sure that there is the correct amount of grease inside the boot and the differential internal driveshaft.
1. Fit and new boot and band (1a) securing it to the differential internal driveshaft using the tool (1b).
DescriptionCodeFunction
1bCaliper1.870.857.000Constant velocity joint gaiter installation
Tighten the bolts fixing the steering knuckle to the shock absorber to torque.
Value - daNmFasteningComponentØ  
.19BoltFRONT HUB STRUTM16
. Tighten the nut fixing the ball joint to the steering rod to torque.
Value - daNmFasteningComponentØ  
.6.9NutADJUSTABLE LINK BALL JOINTSM16
Fit the brake caliper - bracket assembly and tighten the bolts fixing the bracket to the left disc to torque.
Value - daNmFasteningComponentØ  
.21BoltFRONT BRAKE CALIPER BRACKETM16