244001065 - 2710A31 INTERMEDIATE DRIVE SHAFT - R R

Removing ( Refitting ) - Position the vehicle on a lift.    Op. 4450B04 RIGHT FRONT WHEEL R R    Op. 7055B54 UNDER-ENGINE GUARD - R R- Have a suitable container for collecting the transmission fluid ready.1. Undo the plug, using a suitable spanner, and drain the transmission fluid.
DescriptionCodeFunction
.Spanner1.850.182.000Wrench for slackening/tightening differential fluid plug
- Position a hydraulic lift under the track control arm to work safely.1. Undo the nut fixing the track rod end to the steering knuckle.2. Extract the track rod end (2b) from the housing in the steering knuckle using the tool (2a).
DescriptionCodeFunction
2aHead extractor1.847.038.000Ball joint removal
- Remove the rpm sensor from the housing in the wheel hub. 1. Undo the fixing bolts (1a) and remove the brake caliper-bracket assembly (1b) from the brake disc without disconnect the fluid pipes.
1. Remove the staking and undo the right hub nut.2. Undo the bolts fixing the steering knuckle to the shock absorber.3. Undo the nuts (3a) and remove the right driveshaft (3b) complete with intermediate shaft (3c).
    Op. 2710A30 INTERMEDIATE DRIVE SHAFT - R + R WITH R/H DRIVE SHAFT REMOVED Refitting ( Removing )     Op. 2710A30 INTERMEDIATE DRIVE SHAFT - R + R WITH R/H DRIVE SHAFT REMOVED- Fit the right driveshaft - intermediate driveshaft assembly.- Tighten the nuts fixing the intermediate driveshaft to the support to torque.
Value - daNmFasteningComponentØ  
.-NutINTERMEDIATE DRIVE SHAFT-
- Tighten the bolts fixing the steering knuckle to the shock absorber to torque.
Value - daNmFasteningComponentØ  
.(damper strut) 19BoltFRONT HUB STRUTM16
- Tighten the nut fixing the ball joint to the steering rod to torque.
Value - daNmFasteningComponentØ  
.6.9NutADJUSTABLE LINK BALL JOINTSM16
- Fit the brake caliper - bracket assembly and tighten the bolts fixing the bracket to the disc to torque.
Value - daNmFasteningComponentØ  
.21BoltFRONT BRAKE CALIPER BRACKETM16
- Remove the rpm sensor from the housing in the wheel hub. 1. Use a hammer and chisel to stake the wheel hub drive shaft retaining nut as shown in the figure.- The figure below refers to the 15 quintal version.
Value - daNmFasteningComponentØ  
.37NutFRONT HUBS COMPLETE WITH BEARINGM28
- The figure below refers to the 1800 kg version.
Value - daNmFasteningComponentØ  
.42NutFRONT HUBS COMPLETE WITH BEARINGM33
    Op. 7055B54 UNDER-ENGINE GUARD - R R    Op. 4450B04 RIGHT FRONT WHEEL R R    Op. 0010T40 MANUAL GEARBOX OIL CHECK LEVEL AND TOP UP IF NECESSARY- Remove the vehicle from the lift.