3310A30 FRONT BRAKE CALIPER ONE R R - Fiat - DUCATO - eLearn

244001079 - 3310A30 FRONT BRAKE CALIPER ONE R R

) - Remove the front wheel.1. Undo the brake pipe connectors.2. Release the flexible brake pipe retaining springs.3. Release the flexible pipes from the support housings.

1. Cut the bands (1) securing the electrical wiring.2. Disconnect the electrical connection for the brake pad wear sensor.

	Description	Connector
2	Left brake pad wear sensor (switch)	K020

3. Disconnect the bands for the pipes from the support.4. Undo the bolts fixing the brake caliper.

The bolts fixing the brake caliper are self-locking and should therefore always be replaced each time they are undone or loosened.

5. If necessary, undo the connectors and keep the flexible brake pipes.

1. If necessary, remove the brake pads (1a), then undo the bolts (1b) and remove the brake back plate (1c).

The bolts fixing the brake back plate are self-locking and should therefore always be replaced each time they are undone or loosened.

Refitting ( Removing

) - If it has been removed, position the brake back plate and tighten the new bolts.

	Value - daNm	Fastening	Component	Ø
.	19 - 28 daNm	Bolt	FRONT BRAKE CALIPER BRACKET	M16x1.5

- If they have been removed, tighten the flexible pipes to the brake caliper.

	Value - daNm	Fastening	Component	Ø
.	1.2 -2.2 daNm	Nut	BRAKING SYSTEM PIPE CONNECTORS	M10x1

- Place the brake caliper in position.- Tighten the new bolts fixing the brake caliper.- Connect the electrical connection for the brake pad wear sensor.

	Description	Connector
.	Left brake pad wear sensor (switch)	K020

- Fit the flexible pipes in the support housings.- Fit the flexible brake pipe retaining springs.- Tighten the brake pipe connectors.

	Value - daNm	Fastening	Component	Ø
.	1.2 -2.2 daNm	Nut	BRAKING SYSTEM PIPE CONNECTORS	M10x1

- Position the electrical wiring and secure it using the bands. Op. 0010T65 HYDRAULIC BRAKE SYSTEM BLEED AIR- Refit the wheel.- Check that the brakes are working.