244001081 - 3310A50 FRONT BRAKE DISCS R R

Removing ( Refitting ) - Position the vehicle on the lift.- Remove the front wheel.1. Disconnect the bands (1a) for the brake pipes from the supports (1b).

The bolts fixing the brake caliper are self-locking and should always be replaced each time they are undone or loosened.

2. Undo the two bolts fixing the caliper to the steering knuckle.3. Release the brake caliper from the disc. 1. Position the brake caliper unit in the wheel housing and secure it without detaching the brake pipes. 1. Undo the bolts.2. Remove the brake disc. 1. The minimum permitted thickness for the brake disc after wear is given below; if the figure is below this, the disc should be replaced.- If there is deterioration or deep grooves, the surfaces of the brake disc can be skimmed using a grinding machine. when the operation is completed the thickness of the brake disc should not be less than the one given below.

	Subject	Value
.	Front brake discs	mm
-	Minimum thickness after grinding	22.9

	Subject	Value
.	Front brake discs	mm
-	Minimum permitted thickness after wear	21.9

	Subject	Value
.	Front brake discs	mm
-	Nominal thickness	24.2 ÷ 23.9

- Disc with outer diameter of 280 mm or 300 mm and thickness of 24 mm. Refitting ( Removing ) - Clean the hub flange where the disc is fitted.1. Place the brake disc in position.2. Tighten the fixing bolts to the recommended torque.

	Value - daNm	Fastening	Component	Ø
.	1.1 - 2.0	Bolt	FRONT BRAKE DISCS	M8

- Check the brake disc non alignment in relation to the rotation axis, this figure should be measured about 2 mm from the outer edge of the disc.

	Subject	Value
.	Front brake discs	mm
-	Brake disc non alignment	< 0.15

- Place the caliper assembly and brake pads in position.- Tighten the new bolts fixing the brake caliper unit.- Connect the brake pipe bands to the supports.- Refit the wheel.- Remove the vehicle from the lift.

brake several times to allow the unit to bed in.

- Check that the brakes are working.