244002630 - 1043A34 FILLER PIPE FROM FITTING TO GPL TANK R R

Removing ( Refitting ) Drain the section of pipe from the LPG filler to the tank, following the instructions in the procedure:    Op. 1043A02 LPG SYSTEM LINES PIPE DRAINING OPERATIONSPosition the vehicle on the lift.Disconnect the negative battery terminal.1. Working from inside the load carrying compartment, release the retaining buttons (1a) and remove the left side trim (1b).
1. Loosen the retaining bands.2. Release the corrugated pipe protecting the LPG filler pipe.
1. Undo the connector (1a) and disconnect the LPG filler pipe (1b) from the filler.
Raise the vehicle.1. Disconnect the connector (1a) on the pipe connected to the 80% valve and disconnect the repressurizing pipe (1b).Release the LPG filler pipe from the fastenings on the body and remove it.
When carrying out this operation it is important not to bend the pipe at all to prevent breaks that could cause leaks of LPG in the future and therefore adversely affect the safety of the system.
Refitting ( Removing ) Check the state of the pipe, in other words make sure that there are no cracks, holes or any other damage that could adversely affect the safety of the system.If it is not okay, replace the entire pipe.
Do not carry out any operations to the pipe (e.g. welding, joins, bends, etc.). Do not apply either oil or grease to any part of the pipe.
Place the pipe inside the protection along the underbody.Tighten the connector for the filler pipe to the pipe connected to the 80% valve to the recommended torque.
Value daNmFasteningComponentØ  
-4ConnectorM20 X 1
When carrying the operation do not pull or bend the pipe.
Lower the vehicle.Restore the position of the corrugated pipe.Tighten the connector for the LPG pressurizing pipe to the filler.
Value daNmFasteningComponentØ  
-4ConnectorM20 X 1
When carrying the operation do not pull or bend the pipe.
Position the corrugated pipe on the LPG pressurizing pipe and secure it using the bands.Raise the vehicle.    Op. 1043A04 GPL SYSTEM AND PIPES CHECK FOR LEAKSPosition the load compartment left side trim and secure it using the retainers.Connect the negative battery terminal.Remove the vehicle from the lift.