244000662 - 1020D18 FRONT CRANK SHAFT COVER OIL SEAL - REPLACE
Removing
(
Refitting
)
Op. 7055B54 UNDER-ENGINE GUARD - R R Op. 4450B04 RIGHT FRONT WHEEL R R Op. 1092B72 POWER STEERING PUMP DRIVE BELT - ALTERNATOR - R&R See in Op. 1092A10 See in Op. 1032D12 See in Op. 1032B10 See in Op. 1032B441. Use the tool described below to fit the oil sealing ring.2. Position the tool extraction pincers (2a) into oil sealing ring grooves (2b).3. Secure the extraction pincers in position using retaining bolts.4. Tighten the tool pin to remove the oil sealing ring from its seat. | Description | Code | Function |
|---|---|---|---|
| 1 | Extractor | 99340058 | Front cover gasket removal |
 | Because the oil seal must always be replaced, it may be destroyed when it is removed. |
Refitting
(
Removing
)
1. Use the tool described below to fit the oil sealing ring.1. Tighten the threaded tool pin until it comes into contact with the crankshaft drive gear seat.- Position the new oil sealing ring in its seat3. Position introduction tool (3a) in contact with the oil sealing ring and tighten into nut (3b) to fully fit the oil sealing ring into its seat on the front cover. | Description | Code | Function |
|---|---|---|---|
| 1 | Fitting tool | 99346254 | Front cover gasket fitting |
