244000697 - 1032B44 TOOTHED DRIVE PULLEY - R + R WITH TIMING BELT REMOVED

Removing ( Refitting ) 1. Position the flywheel lock.2. Undo the fixing bolt (2a) and remove the pulley (2b).
DescriptionCodeFunction
1Counter-torque1.870.765.000Flywheel lock
Refitting ( Removing ) - Position the pulley in the special housing on the crankshaft.- Tighten the fixing bolt to torque.
Value - daNmFasteningComponentØ  
.35BoltDRIVE PULLEY(PULLIES) TIMINGM18x1.5
- Remove the flywheel lock.
DescriptionCodeFunction
.Counter-torque1.870.765.000Flywheel lock
Removing ( Refitting )     Op. 1020D10 FRONT CRANK SHAFT OIL SEAL COVER - R + R AND REPLACE SEALS WITH TIMING BELT REMOVED1. Make two millings on the toothed drive pulley (1a) and remove the pulley using a suitable extractor (1b).
Refitting ( Removing ) - Place the toothed drive pulley in the oven.1. Fit the drive pulley ensuring that the groove (1a) coincides with the key (1b).
- Take the pulley out of the oven using suitable pliers and fit it on the crankshaft with the help of a drift.
do not exceed 350°C.
    Op. 1020D10 FRONT CRANK SHAFT OIL SEAL COVER - R + R AND REPLACE SEALS WITH TIMING BELT REMOVED