1084B14 ENGINE OIL PUMP - R+R WITH POWER UNIT REMOVED - Fiat - DUCATO - eLearn

244000930 - 1084B14 ENGINE OIL PUMP - R+R WITH POWER UNIT REMOVED

) See in Op. 1004D40 Op. 1032B16 TOOTHED TIMING BELT - R R WITH ENGINE REMOVED1. Undo the bolt (1a) and remove the timing belt toothed drive wheel (1b).

1. Use the tool described below to extract the oil seal.2. Position the tool extraction jaws in the oil seal splining.3. Secure the extraction pincers in position using retaining bolts.4. Tighten the tool pin (4a) to remove the oil seal (4b) from its seat.

Because the oil seal must always be replaced, it may be destroyed when it is removed.

	Description	Code	Function
1	Extractor	99340057	Extracting timig side crankshaft element

1. Undo the bolts (1a) and remove the crankshaft front cover (1b) with vacuum unit and oil pump incorporated plus the gasket (1c).

Refitting ( Removing

) - Fit a new front crankshaft front cover gasket.- Position the crankshaft front cover with vacuum unit and oil pump incorporated and screw in the fixing bolts without tightening them.1. Centre the crankshaft front cover with the vacuum unit and oil pump (1a) incorporated using the tool (1b).

	Description	Code	Function
1b	Locator	99396037	Tool for locating front crankshaft cover

1. Tighten the crankshaft front cover fixing bolts in the recommended order.

	Value - daNm	Fastening	Component	Ø
.	1.0	Bolt	ENGINE OIL PUMP	M6 X 1

1. Use the tool described below to fit the timing side oil seal.

	Description	Code	Function
1	Fitting tool	99346254	Front cover gasket fitting

2. Tighten the threaded tool pin until it comes into contact with the crankshaft drive gear seat.3. Position a new oil seal in its seat.4. Position introduction tool (4a) in contact with the oil seal and tighten the nut (4b) to fully fit the oil seal into its seat on the front cover.

Op. 1032B16 TOOTHED TIMING BELT - R R WITH ENGINE REMOVED See in Op. 1004D40