244000735 - 1040A30 OIL SEAL COVER, FLY WHEEL SIDE - R + R AND REPLACE SEALS

Removing ( Refitting ) - Position the vehicle on the lift.- Disconnect the negative battery terminal. See in Op. 1048A10    Op. 5505A13 SUPPLEMENTARY JUNCTION CONTROL UNIT IN ENGINE BAY - R R See in Op. 1040A401. Undo the fixing nuts.2. Remove the support for the engine compartment junction unit.3. Disconnect the electrical connections (3a), (3b) and (3c) for the fuel filter.
DescriptionConnector
3aFuel temperature sensorK081
DescriptionConnector
3cWater in diesel filter sensorK031
DescriptionConnector
3bDiesel heating resistanceO020
4. Undo the bolts fixing the fuel filter to the bodyshell.
1. Remove the junction unit mounting bracket.
1. Remove the fuel filler cap.2. Undo the bolts fixing the fuel filler pipe to the bodyshell.
1. Undo the fixing nut located under the brake servo.- Release the filler pipe from the bands securing the electrical wiring.- Raise the lift.    Op. 7055B54 UNDER-ENGINE GUARD - R R2. Undo the lower bolts fixing the filler pipe to the bodyshell.3. Disconnect the flexible section of the fuel filler pipe (3a) and the reflux pipe (3b) from the tank.- Lower the lift.4. Separate the two sections of the pipe working on the retaining band.5. Remove the pipe in two sections.
1. With the filler pipe at the bench, remove the filler internal plastic protection.
1. Remove the plate with the threaded connector for the fuel cap from the filler pipe.
Refitting ( Removing ) - Fit the plate with the threaded connector for the fuel cap on the filler pipe.- Fit the filler internal plastic protection.- Fit the tank section of the fuel filler pipe and then connect the next section securing them with the retaining band.- Raise the lift.- Connect the flexible section of the fuel filler pipe (3a) and the reflux pipe (3b) to the tank.- Tighten the lower bolts fixing the filler pipe to the bodyshell.    Op. 7055B54 UNDER-ENGINE GUARD - R R- Lower the lift.- Secure the electrical wiring to the filler pipe.- Tighten the fixing nut located under the brake servo.- Tighten the bolts fixing the fuel filler pipe to the bodyshell.- Secure the wiring to the filler pipe.- Fit the junction unit mounting bracket.- Tighten the nuts fixing the fuel filter to the bodyshell to torque.
Value - daNmFasteningComponentØ  
.(body) 3.5NutsFUEL FILTERM10
- Connect the electrical connections for the fuel filter.
DescriptionConnector
.Fuel temperature sensorK081
DescriptionConnector
.Diesel heating resistanceO020
DescriptionConnector
.Water in diesel filter sensorK031
- Fit the engine compartment junction unit mounting and tighten the fixing nuts. See in Op. 1040A40    Op. 5505A13 SUPPLEMENTARY JUNCTION CONTROL UNIT IN ENGINE BAY - R R See in Op. 1048A10- Connect the negative battery terminal.- Remove the vehicle from the lift.