244000836 - 1060F10 FUEL INJECTORS

Removing ( Refitting ) See in Op. 1016A10 See in Op. 1060F361. Disconnect the electrical connections for the injectors.
DescriptionConnector
1InjectorN070A
DescriptionConnector
1InjectorN070B
DescriptionConnector
1InjectorN070C
DescriptionConnector
1InjectorN070D
2. Disconnect the fuel recirculation pipe attachment.3. Undo the fixing bolt (3a) and remove the injector (3b).- Carry out the same operation on all the injectors
Refitting ( Removing ) - Fit the injector in place.
To improve the operation of the engine and guarantee the emission limits, an injector classification criterion has been introduced. If the injectors are replaced the following must be taken into account:The Bosch number and class to which it belongs (1, 2, 3 or 2C inside a rim), which is determined according to the amount of fuel injected into the "emission" control point, is etched, by laser, on each injector on the top part of the magnet.If an injector is being replaced, a new injector of the same grade must be fitted.
- Tighten the fixing bolt and check the torque.- Connect the fuel return pipe.
DescriptionConnector
.InjectorN070B
- Connect the electrical connection.
DescriptionConnector
.InjectorN070A
DescriptionConnector
.InjectorN070D
DescriptionConnector
.InjectorN070C
- Carry out the same operation on all the injectors See in Op. 1060F36 See in Op. 1016A10