1. Working from inside the vehicle, undo the bolts fixing the lower dashboard trim.2. Remove the lower dashboard trim.3. Undo the fixing bolts.4. Remove the lower steering column trim.
1. Remove the spring fastening the brake servo push rod to the brake pedal.2. Remove the pin from the brake pedal.3. Undo the nuts fixing the brake servo to the pedal assembly.- Move the pedal assembly as far away as possible from the bodyshell.
- There are four nuts under the pedal assembly fastening the brake servo to the bodyshell.1. To gain access to the nuts it is necessary to cut a 13 mm diameter key creating a slit of about 8 mm.
1. Undo the nuts fixing the brake servo to the bodyshell.2. Disconnect the single-acting valve from the brake servo.3. Remove the brake servo from the housing.
Refitting
(
Removing
)
- Place the brake servo in position, connect the single-acting valve and tighten the brake servo fixing nuts.
Value - daNm
Fastening
Component
Ø
.
1.8 - 2.7
Nut
BRAKE SERVO
M8
- Position the pedal assembly and secure it to the brake servo using the nuts.- Attach the brake pedal to the brake servo push rod, insert the pin and secure it using the spring.- Position the lower steering column trim and fasten it.- Position the lower dashboard trim and fasten it.- Working via the engine compartment, tighten the nuts fixing the pedal assembly to the bodyshell.
Removing
(
Refitting
)
Op. 3330C30 BRAKE FLUID RESERVOIR - R + R AND WASH INSIDE Op. 3330C10 MASTER CYLINDER (PUMP) - R + R1. Working via the engine compartment, undo the nuts fixing the pedal assembly to the bodyshell.
