244001187 - 4410D14 FRONT SUSPENSION CROSSBEAM - R+R WITH WISHBONES REMOVED

Removing ( Refitting )     Op. 4410D13 FRONT SUSPENSION BEAM - R R1. Undo the bolts fixing the anti-roll bar.2. Undo the bolts fixing the steering box.3. Undo the bolts fixing the engine reaction rod.4. Working on both sides, release the protection (4a) and undo the rear bolts with the nut (4b) fixing the crossmember to the bodyshell.5. Position a jack under the crossmember.6. Working on both sides, undo the front bolts fixing the crossmember to the bodyshell.7. Remove the crossmember using the jack. Refitting ( Removing ) - Check that the crossmember is not damaged.- Place the crossmember in position with the assistance of the jack.- Tighten the front bolts fixing the crossmember to the bodyshell.

	Value - daNm	Fastening	Component	Ø
.	18.1 - 24.8	Front bolt	ENGINE OR ROD ANCHORAGE BEAM	M16x1.5

- Remove the lifting device.- Tighten the rear bolts fixing the crossmember to the bodyshell.

	Value - daNm	Fastening	Component	Ø
.	18.1 - 24.8	Rear bolt	ENGINE OR ROD ANCHORAGE BEAM	M16x1.5

- Fit the protection.- Tighten the bolts fixing the engine reaction rod.

	Value - daNm	Fastening	Component	Ø
.	11.9 - 17.2	Bolt	LOWER ENGINE FASTENING	M14x1.5

- Tighten the bolts fixing the steering box.

	Value - daNm	Fastening	Component	Ø
.	9.6 - 14.1	Bolt	steering box	-

- Tighten the bolts fixing the anti-roll bar.

	Value - daNm	Fastening	Component	Ø
.	7.7 - 11.2	Bolt	FRONT ANTI-ROLL BAR	M12x1.5

    Op. 4410D13 FRONT SUSPENSION BEAM - R R    Op. 4450A10 FRONT WHEEL GEOMETRY - CHECK USING OPTICAL EQUIPMENT - INCLUDES FRONT WHEEL TOW-IN ADJUSTMENT IF NECESSARY    Op. 4450A20 FRONT WHEEL CASTER