244001190 - 4420A30 L/H OR R/H REAR SUSPENSION DAMPER (ONE) - R+R

Removing ( Refitting ) - Position the vehicle on the lift.- Remove the rear wheel.- Working underneath the vehicle, with the help of a jack, slightly raise the axle on the side of the shock absorber to be removed.1. Undo the shock absorber fixing bolts.2. Remove the shock absorber.
Refitting ( Removing ) - With the help of the jack, kee the rear axle raised, position the shock absorber and screw in the bolts without tightening them.- Refit the rear wheel.- Remove the vehicle from the lift.1. The definitve tightening of the shock absorber fixing bolts should be carried out in the design load conditions. Therefore the vehicle should be suitably loaded over the rear axle so that the distance (L) between the buffer plane and the buffer support plane corresponds to the recommended figure (leaf spring in horizontal position).
SubjectValue
1Rear axle - Ducato 10 - 14mm
-Distance "L" between buffer plane and buffer support plane192
--Ducato 10 - 14
SubjectValue
1Rear axle - Ducato Maximm
-Distance "L" between buffer plane and buffer support plane197
--Ducato Maxi
- The following loads must be applied to the vehicle in the area of the rear axle to obtain the recommended distance.- Ducato 10 van and lorry: 850 kg- Ducato 10 panorama: 650 kg- Ducato 14 van: 1100 kg- Ducato 14 lorry: 1200 kg- Ducato Maxi van: 1250 kg- Ducato Maxi lorry: 1400 kg
Given the impossibility of applying a load of 650 kg to the rear seats on the Panorama versions, simply apply a load of 500 kg in the rear luggage compartment between the third row of seats and the rear doors.
1. Tighten the shock absorber fixing bolts.
Value - daNmFasteningComponentØ  
114.7 - 20.9BoltREAR SHOCK ABSORBERM16x1.5
- Remove the ballast.