244001289 - 5040C12 AIR CONDITIONER HOUSING - R R WITH FACIA DISCONNECTED

Removing ( Refitting )     Op. 0010T20 COOLANT CHECK DENSITY AND TOP UP IF NECESSARY    Op. 0010T84 COOLANT FOR AIR CONDITIONING SYSTEM DEHYDRATE AND RECHARGE1. Remove the retaining bands.2. Disconnect the pipes from the heater tap.
1. Undo the fixing bolts.2. Disconnect the air conditioning system pipes from the expansion valve connector.
- Mark the control cables.1. Undo the fixing bolts.2. Disconnect the control cables.3. Remove the heater controls support.
- Undo the bolts fixing the dashboard trim supporting crossmember.1. Disconnect the electrical connection for the fan resistance.
DescriptionConnector
1Passenger compartment air fan adjustment resistanceO030
2. Disconnect the electrical connection for the fan.
DescriptionConnector
2Passenger compartment air fanN085
3. Undo the lower fixing nut.
1. Undo the nut (1a) and disconnect the earth (1b).
DescriptionConnector
1bPassenger dashboard earthC020
2. Undo the fixing bolt.
1. Undo the fixing bolts.
- Disconnect the electrical connection for the frost thermostat on the air conditioning casing.
DescriptionConnector
.Frost sensorK086
- Open the retaining bands and move the electrical wiring aside.- With the help of a second mechanic, lift up the dashboard trim supporting crossmember.- Remove the air conditioning casing. Refitting ( Removing ) - With the help of a second mechanic, lift up the dashboard trim supporting crossmember and place the air conditioning casing in position.- Tighten the bolts fixing the dashboard trim supporting crossmember.- Tighten the bolts and the nut fixing the air conditioning casing.- Refit the electrical connections.
DescriptionConnector
.Frost sensorK086
DescriptionConnector
.Passenger compartment air fanN085
DescriptionConnector
.Passenger compartment air fan adjustment resistanceO030
- Place the earth in the wheel arch and tighten the fixing nut.
DescriptionConnector
.Passenger dashboard earthC020
- Position the wiring and secure it using the retaining bands.- Position the heater controls support.- Connect the control cables marked previously and tighten the fixing bolts.- Connect the air conditioning system pipes to the expansion valve connector and tighten the fixing bolts.
Check the condition of the seals and, if necessary, replace them.
- Connect the pipes to the heater tap and secure them using the retaining bands.    Op. 0010T84 COOLANT FOR AIR CONDITIONING SYSTEM DEHYDRATE AND RECHARGE    Op. 0010T20 COOLANT CHECK DENSITY AND TOP UP IF NECESSARY