244005918 - E5050 DIESEL ENGINE ELECTRONIC MANAGEMENT FUNCTIONAL DESCRIPTION

Operational Description

Engine management control unit M10 controls and governs the entire electronic ignition and injection system.Engine bay control unit B001 houses fuses F02, F11, F17, F18, F20, F21, F22, and relays T19, T09, T10, designed to protect and control the supply to engine management unit M010 and the various sensors and solenoids.Main injection relay T09 controls the entire system: t is energized by an earth signal from pin 13 of connector A of engine control unit M010 and then forwards a power supply:

to pin 4 of the control unit via the line of fuse F17 of B001;
to pin 5 of the control unit via the line of fuse F22 of B001;
to sensors: L064, L036, K044, L085;
thermal starter O004.

Fuel pump relay T10 of B001 is supplied by the line of fuse F21.This is excited by a control signal (earth) from pin 110 connector B of control unit M10 and supplies power to diesel heater coil O020.Relay J131 governs the power supply thermal starter coil O004. The power supply to the relay comes from a line protected by fuse F11. Engine management unit M010 excites the coil of J131 via an earth signal from pin 15 of connector A. The power supply supplied to coil O004 comes directly from the battery and is protected by fuse F02.Alternatively, the diesel is preheated by means of the HEAT-FLANGE system. The system heats air coming into the input manifold by means of a glow coil. Relay J131 receives an earth signal from engine management unit M010 - pin 15 connector A - and supplies power supply direct from the battery to resistance device O003. A dedicated fuse F74 protects the power supply from the resistance load.Control unit M010 receives signals from the various sensors in order to control all engine service parameters.Engine temperature sensor K036 communicates with engine management unit M010 at pins 82 and 83 of connector B.The air pressure/temperature sensor K044 is connected to pins 86, 93, 94, 95 of control unit M010 from which it receives a power supply and to which it provides a reference signal.Accelerator pedal K055 contains two integral potentiometers (a main one and a safety one). The former receives power and an earth signal from pins 78 and 76 of M010 respectively and sends a corresponding signal to pin 77. The latter receives power and an earth signalfrom pins 81 and 79 respectively and sends a signal to pin 80.The flow modifier solenoid valve L064 receives a power supply from the line for fuse F11 and is controlled by a signal for pin 111 connector B of M010.The variable geometry turbine solenoid valve L036 receives a power supply from the line for fuse F11 and is controlled by a signal for pin 16 connector A of M010.Injectors N070 receive a power supply to enable opening from pins 117 (cylinders 1 and 2) and 118 (cylinders 3 and 4) of M010.The engine management unit sends a command to injectors N070 from 119, 120, 121 and 114 for cylinders 1, 2, 3 and 4 respectively.The engine management control unit M010 is connected from pins 99, 100 and 102, 103, 104 with the rpm sensor. K046 and with the timing sensor K047. See E4020 REV COUNTER INSTRUMENTEngine management unit M010 is equipped with a CAN connection - from pins 9 and 10 connector A - to ABS control unit M050 - pins 29 and 30 -.Engine management unit M010 governs activation of the warning lights on instrument panel E050 from pins 21 and 14 of connector A if the injection system malfunctions.