312000182 - T005 BONNET WIND NOISE

With the vehicle moving, there is noise coming from the front area of the passenger compartment.

		Test results
0	PRELIMINARY CHECKS	All OK	Problems encountered	Operation
	As a preliminary step, check the bonnet closes correctly. Check that the wind noise actually comes from the bonnet	Move on to Step 1	1. The wind noise is coming from the front doors2. The wind noise is coming from the windscreen3. The wind noise is coming from the lower part of the passenger compartment4. The wind noise is coming from the sun roof5. The wind noise is coming from the rear area	1. Proceed as instructed    See table T001 WIND NOISE FROM THE FRONT DOORS2. Proceed as instructed    See table T006 WINDSCREEN WIND NOISE3. Proceed as instructed    See table T010 PASSENGER COMPARTMENT WIND NOISE, LOWER AREA (UNDERBODY)4. Proceed as instructed    See table T020 WIND NOISE FROM THE SUN ROOF 5. Proceed as instructed    See table T025 WIND NOISE FROM THE REAR AREA
1	CHECK ON LOCATION OF WIND NOISE FROM BONNET	All OK	Problems encountered	Operation
	Carry out a test to locate the wind noise from the bonnet accurately: locate the area where the wind noise is coming from    See Test 7025OA LOCATING THE BONNET WIND NOISE	Move on to Step 2	1. The wind noise is coming from the side area of the bonnet2. The wind noise is coming from the area of the grille3. The wind noise is coming from the front area of the bonnet.	1. Check the foam buffers where the bonnet and the wings are matched at the rear. Also check the condition of weatherstrips and make sure they are fitted correctlyOp. 7025A62 BONNET LID WEATHERSTRIP - R+R2. Check for the seal between the bonnet and the radiator grille3. Check the condition of the front weatherstrip and make sure it is fitted correctlyOp. 7025A62 BONNET LID WEATHERSTRIP - R+R
2	FLAME BULKHEAD CHECK	All OK	Problems encountered	Operation
	Check the flame bulkhead. In particular, check:- the plugs are present;- the plugs are correctly fitted.- the bulkhead coupling rubber seals are fitted correctly;- sealant properly applied;- correct installation.	End of diagnosis	Flame bulkhead faulty	Renew flame bulkhead