312000464 - 44B ROAD TEST TO EVALUATE ROLL/PITCHING

- Carry out a road test on traffic-free roads in safe conditions, following the highway code.- Before proceeding with the test, check the inflation pressure of the two vehicles, restoring the values to the correct ones if they are found to be incorrect.- Carry out the test on a route where there are left and right hand bends of different degrees, evaluating the dipping speed of the vehicle round the bends, trying to take the bends at a constant speed, avoiding carrying out pull/release manoeuvres.- Evaluate the stability of the vehicle by simulating a lane change/overtaking and check that violent vehicle reactions do not appear leading to unsafe driving during this manoeuvre.- Then carry out a road test on an unmade road (transverse rails, cobblestones, paving stones) where there are right/left-hand bends of different degrees to evaluate the tendency of the rear of the vehicle to lose grip (drift).- This type of test should always be used for comparison with a new vehicle or reference vehicle of the same trim level and engine type, available in the workshop at the time of the test in question.- At the end of the test in question, assess/rate the behaviour of the vehicle in terms of rolling/pitching in accordance with the enclosed table.

ASSESSMENT	RATING
Poor	3
Mediocre	4
Just acceptable	5,5
Acceptable	6
Good	7

The reference vehicle has a rolling/pitching default rating of 7.