| | Test results |
| 1 | CHECK USING THE EXAMINER | All OK | Problems encountered | Operation |
|---|
| Connect using the Examiner and check that there are no faulty control units in the CAN information | Move on to Step 2 | Control unit faulty | Continue as instructed by the diagnostic equipment |
| 2 | ACTIVE DIAGNOSIS CHECK | All OK | Problems encountered | Operation |
|---|
| With the Examiner check in Active Diagnosis mode that the water in the diesel fuel filter warning light activates correctly. | Move on to Step 3 | The warning light does not flash. | Replace the Instrument Panel Op. 5560B10 CONTROL PANEL - R+R |
| 3 | CHECK USING THE EXAMINER | All OK | Problems encountered | Operation |
|---|
| Connect to the engine management control unit and check that there are no errors | Move on to Step 4 | Presence of errors | Continue as instructed by the diagnostic equipment |
| 4 | CHECK OPERATION OF SENSOR DETECTING PRESENCE OF WATER IN FILTER | All OK | Problems encountered | Operation |
|---|
| Check correct operation of the water in diesel filter sensor. | End of diagnosis | 1. Power supply interrupted2. Wiring defective3. Sensor defective4. Presence of water in the filter | 1. Restore the correct power supply.2. Restore correct wiring.3. Replace the fuel filter assembly Op. 1044B10 FUEL FILTER ASSEMBLY - R + R OR REPLACE 4. Eliminate the water from the diesel filter. |