| STEP | CHECK TO BE PERFORMED | REMEDIAL ACTION IF THE CHECK IS NOT OK |
|---|
| 1 | Remove the battery cover. Check visually that the battery terminals are not oxidised | Clean the layer of oxidation from the terminals |
| 2 | The water gauge (magic eye) should not be white indicating that the electrolyte level is too low. | Replace the battery Op. 5530B10 BATTERY - R+R |
| 3 | The plugs or caps should not be damaged or incorrectly positioned | Replace the battery Op. 5530B10 BATTERY - R+R |
| 4 | There should be no damage to the main body of the battery, the cover or the terminals | Replace the battery |
| 5 | There should be no signs of electrolyte escaping from the battery (wet areas or large salt deposits) | Clean the area involved and top up to the correct level |
| 6 | Check that the vehicle has been unused for at least 30 minutes. Disconnect the negative terminal and check the charge status using the MIDTRONIC equipment tool code 1806515000, making sure to perform the check by connecting directly to the battery terminals. The instrument must supply one of the following signals "CHARGE RETEST" OR "BATT. OK+RECHARGE" or the display will remain off.Move on to Step 11 | Move on to Step 7 |
| 7 | The equipment will give one of the following signals "REPLACE BATT." or "CELL SHORT". Move on to Step 10 | Move on to Step 8 |
| 8 | Check the electrical connections for the supply circuit are correct with particular reference to the power supplies and earths See E1010 POWER SUPPLY | Restore the correct connections See E1010 POWER SUPPLY |
| 9 | Reconnect or refit the battery on the vehicle and try and start the engine several times (at least 6 or 7) with about 4-5 seconds between each attempt. Ensure the start-ups are successful. The test may be considered to be concluded | Continue with Step 4 of the See Test 5530B BATTERY AND LEADS |
| 10 | Replace the battery Op. 5530B10 BATTERY - R+R The test can be considered over | |
| 11 | Rechare the battery using tool 1806151001 | |
| 12 | Check the charge status using a MIDTRONIC equipment, tool code 1806515000, ensuring the test is carried by connecting directly to the battery terminals. The gauge must supply one of the following signals “CHARGE RETEST”, “REPLACE BATT.” or “CELL SHORT” or the display will remain off. Go on to Step 9 | Move on to Step 10 |