312002302 - 1036H52 HYDRAULIC TAPPET (ONE) - R.R.
Removing
(
Refitting
)
- Position the vehicle on the lift. Op. 0010T20 ENGINE COOLANT - CHANGE Op. 5530B10 BATTERY - R+R Op. 5530B52 BATTERY SUPPORT/DRIP TRAY - R.R Op. 1048A10 AIR FILTER ASSEMBLY - R.R. Op. 1048A23 COLD AIR INTAKE FOR AIR FILTER - R.R Op. 1044B10 FUEL FILTER ASSEMBLY - R + R OR REPLACE Op. 1076B20 REAR EXHAUST SILENCER - R + R Op. 1076B40 CENTRE EXHAUST PIPE - R.R. - Follow the instructions in the procedure for all the pipes from the fuel manifold to the injector: Op. 1060F34 PIPE FROM FUEL MANIFOLD TO INJECTOR - R.R. Op. 1060G22 CAM ANGLE SENSOR - R.R - Follow the instructions in the procedure for all the injectors: Op. 1060F11 INJECTOR ONE R R Op. 1060F52 FUEL RETURN PIPE FROM INJECTORS - R.R. Op. 1088B10 ENGINE COOLANT SUPPLY RESERVOIR - R.R. Op. 1008B10 POWER UNIT FRONT SUPPORT FLEXIBLE MOUNTING (TIMING SIDE) - REPLACE Op. 1008A46 POWER UNIT RIGID SUPPORT - TIMING SIDE - R.R. Op. 1016B10 SINGLE CAMSHAFT HOUSING - REPLACE GASKET
1. Remove the valve rockers.2. Remove the hydraulic tappet.
Refitting
(
Removing
)
- Lubricate the hydraulic tappets with engine oil, then place them in their housings. | Position the hydraulic tappets with the oil channel hole turned toward the outside of the lower cylinder head: this position brings the hole into communication with the oil duct on the lower cylinder head. |