312002332 - 1060G28 FUEL PRESSURE SENSOR ON FUEL MANIFOLD TO INJECTORS - R.R

Removing ( Refitting ) - Disconnect the negative battery terminal.
DescriptionConnector
-Battery    See A001 BATTERY
    Op. 1048A10 AIR FILTER ASSEMBLY - R.R. 1. Detach the fuel pressure sensor electrical connection.
DescriptionConnector
1Fuel pressure sensor    See K083 FUEL PRESSURE SENSOR
2. Undo the fuel pressure sensor and remove it.
Refitting ( Removing ) 1. Place the fuel pressure sensor in position.2. Connect the electrical connection for the fuel pressure sensor.
DescriptionConnector
2Fuel pressure sensor    See K083 FUEL PRESSURE SENSOR
- If the pressure sensor is being replaced, some of the procedures must be carried out using the diagnostic equipment in order to reset some of the self-adjustment data contained in the engine management control unit to restore their value to the preset ranges

In order to carry out this procedure it is necessary to:

  • connect the diagnostic equipment;
  • with the engine off, turn the ignition key to the ON position;
  • follow the instructions given by the diagnostic equipment for this procedure;
  • at the end of the operation, turn the ignition key OFF and wait until the data has been memorized.
    Op. 1048A10 AIR FILTER ASSEMBLY - R.R. - Connect the negative battery terminal.
DescriptionConnector
-Battery    See A001 BATTERY