312000640 - K060 ABS FAILURE WARNING LIGHT ON

N.B: The Brake Node sends the ABS warning light on message via the C-CAN to the Body Computer which makes it available via the gateway to the Instrument Panel Node through the B-CAN.
Test results
0PRELIMINARY CHECKSAll OKProblems encounteredOperation

Connect an EXAMINER and check the following on CAN NETWORK INFORMATION:

  • No control units inactive
  • No faulty control units
  • ABS control unit connector correctly fitted
Move on to Step 11.Fault in CAN2. ABS control unit connector not correctly connected1. Continue following the instructions given by the diagnostic equipment2. Fit the ABS control unit connector correctly
1CHECK USING DIAGNOSTIC EQUIPMENTAll OKProblems encounteredOperation

Keeping the diagnostic instrument connected, check the following on the BRAKE NODE:

  • No system/component errors
  • No CAN faults
Move on to Step 21. System/components faulty2. Fault on C-CAN network1. Continue following the instructions given by the diagnostic equipment2. Continue following the instructions given by the diagnostic equipment
2CHECK USING DIAGNOSTIC EQUIPMENTAll OKProblems encounteredOperation
Using the Examiner diagnostic equipment check, in Instrument Panel mode, that there are no errors and that the parameters are present.Move on to Step 3Presence of errorsContinue by following the instructions on the diagnostic equipment.
3ACTIVE DIAGNOSIS CHECKAll OKProblems encounteredOperation
With the Examiner in the Instrument Panel Node ambient check that the ABS warning light is correctly activated in Active DiagnosisEnd of diagnosisThe ABS warning light does not flashReplace the Instrument Panel    Op. 5560B10 CONTROL PANEL - R+R