312000641 - K061 ABS WARNING LIGHT OFF (INTIAL TEST NOT CARRIED OUT)

The ABS warning light does not come on at key on (it should come on for 3 seconds to indicate that the initial control unit test has been carried out, and then go off)

		Test results
1	CHECK USING DIAGNOSTIC EQUIPMENT	All OK	Problems encountered	Operation
	Connect to the Examiner and check in CAN INFORMATIONNo faulty control units	Move on to Step 2	Control unit faulty	Continue following the instructions on the diagnostic equipment
2	INSTRUMENT PANEL CHECK	All OK	Problems encountered	Operation
	Check that the ABS warning light located on the instrument panel activates correctly during active diagnosis    See E4010 INSTRUMENT PANEL The warning lights take the form of LEDs built into the electronic circuit and are NOT therefore replaceable	End of diagnosis	The warning light does not flash	Replace the Instrument Panel    Op. 5560B10 CONTROL PANEL - R+R