K066 HANDBRAKE WARNING LIGHT DOES NOT COME ON (WITH HANDBRAKE APPLIED) - Fiat - NUOVA 500 - eLearn

312000644 - K066 HANDBRAKE WARNING LIGHT DOES NOT COME ON (WITH HANDBRAKE APPLIED)

The command to switch on the handbrake warning light is sent by the switch on the lever to the Body Computer Node which makes it available on the B-CAN to the Instrument Panel Node

0	PRELIMINARY CHECKS	All OK	Problems encountered	Operation
		Test results
	Check that the warning light comes on during the check when the panel is switched on	Move on to Step 3	The warning light does not come on.	Move on to Step 1
1	CHECK USING DIAGNOSTIC EQUIPMENT	All OK	Problems encountered	Operation
	Connect the Examiner diagnostic equipment and check at the Instrument Panel Node that the handbrake warning light is working through active diagnosis	Move on to Step 2	The warning light does not come on / go out on command.	Replace the instrument panel Op. 5560B10 CONTROL PANEL - R+R
2	ELECTRICAL SYSTEM CHECK	All OK	Problems encountered	Operation
	Check: the continuity of the wiring between the handbrake lever switch and the Body Computer. See E4010 INSTRUMENT PANEL	Move on to Step 3	Wiring broken.	Restore correct wiring See E4010 INSTRUMENT PANEL
3	HANDBRAKE SWITCH CHECK	All OK	Problems encountered	Operation
	Switch operation check	Move on to Step 4	Switch defective	Replace the switch Op. 5550D18 HANDBRAKE ON WARNING LIGHT SWITCH - R+R
4	CHECK USING DIAGNOSTIC EQUIPMENT	All OK	Problems encountered	Operation
	Using the Examiner, check that the body computer is working properly	End of diagnosis	Body Computer defective.	Replace Body Computer Op. 5505A32 BODY COMPUTER - R.R