| | Test results |
| 0 | PRELIMINARY CHECKS | All OK | Problems encountered | Operation |
|---|
| "Rock" in the seat resting against the backrest; check the fastenings to the floor (four M8 bolts) releasing the tension and check the front and rear mountings. | Move on to Step 1 | Creaking; non alignment of guides during sliding stage (twist effect). | Retighten the seat to the floor following the correct guide alignment cycle. |
| 1 | CHECK ON GUIDE FASTENINGS TO SEAT | All OK | Problems encountered | Operation |
|---|
| Check whether the noise disappears by releasing the tension of the fastenings securing the guides to the seats (6 M8 bolts on the 4 way seat and 2 M8 bolts on the 6 way seat). | Move on to Step 2 | Noise disappears | Retighten the seat to the floor following the correct tightening cycle. |
| 2 | SEAT LIFTING HINGES CHECK | All OK | Problems encountered | Operation |
|---|
| Check for clearance at the seat lifting hinges | Move on to Step 3 | Excessive clearance in the seat lifting hinges. | Replace the seat lifting assembly.Op. 7045A36 |
| 3 | BRACKET HOLDER CONTACT CHECKS | All OK | Problems encountered | Operation |
|---|
| Check for the presence of contacts or detachment of the bracket. | Move on to Step 4 | 1. Contact with cushion components2. Detachment of the bracket | 1. Move the bracket away from possible contact with the cushion.2. Replacement of connector holder bracket. |
| 4 | SUSPENSIONMAT FASTENINGS CHECKS (LUMBAR SUSPENSION) | All OK | Problems encountered | Operation |
|---|
| Check for possible detachment of the suspensionmat fastenings on the frame or possible breaks. | End of diagnosis | Suspensionmat released or broken. | Reattach suspensionmat or replace suspensionmat Op. 7045A79 FRAME OF TILTING CUSHION OF A FRONT SEAT, LEFT OR RIGHT - R.R . |
