312003036 - 7055C04 ADHESIVE STRIPE ON SIDE FRONT BONNET (ONE), LEFT OR RIGHT - R.R.

Removing ( Refitting )

The stickers should be removed and fitted at ambient temperature and the bodywork should be cleaned first.

1. Heat the sticker with a hot air blower.

Carry out the operation for a length of about 20 centimetres.

- Remove the part of the sticker heated previously.- Repeat the operation several times along the entire length of the sticker.- Clean the residual adhesive using the special product - 3m Cleaner Spray. Refitting ( Removing ) - Clean the area where the sticker will be fitted using a cloth. 1. Place the sticker (1a) on the bonnet using the profile (1b) as a reference and allow the adhesive section to protrude about 5 mm beyond the profile of the bonnet (1c) to allow it to be turned over later on. - If necessary, secure the position of the sticker using adhesive tape. 1. Remove the lower protective film and stick the sticker to the bonnet taking care not to produce bubbles or folds. 1. With the help of the buffer stick the sticker working gently from the middle towards the top and from the middle towards the bottom. - Remove the upper protective film for the sticker.

handle the stickers carefully: check for stretching, distortions or breaks.

1. With the help of the buffer extend the sticker along its entire length. 1. Turn the sticker over and stick to the edges of the bonnet.

If there are bubbles in the stickers are they have been fitted, pierce them using a needle and stretch them again over the surrounding area using the special spatula.

Keep the vehicle under cover for at least one hour after fitting the stickers.

Avoid washing the vehicle for 24 hours after the stickers have been fitted.