312000508 - 5040A67 PIPE FROM EXPANSION VALVE TO CONDENSER - R.R.

Removing ( Refitting ) - Position the vehicle on a lift.- Drain the air conditioning system.    Op. 0010T20 ENGINE COOLANT - CHANGE     Op. 0010T84 COOLANT FOR AIR CONDITIONING SYSTEM - DEHYDRATE AND REPRESSURIZE - Disconnect the negative battery terminal.

	Description	Connector
-	Battery	See A001 BATTERY

    Op. 1088B10 ENGINE COOLANT SUPPLY RESERVOIR - R.R.     Op. 4450B12 FRONT WHEELS (TWO) - R+R     Op. 4410D22 BRACKET FIXING FRONT SUSPENSION CROSSMEMBER TO BODYSHELL (ONE), LEFT OR RIGHT - R.R.     Op. 7055B66 ENGINE COMPARTMENT DUST COVER IN RIGHT FRONT WHEEL ARCH - R.R.     Op. 7210E10 R.R. FRONT BUMPER 1. Undo the fixing nut (1a) and disconnect the low pressure pipe (1b), expansion valve side.2. Undo the fixing nut (2a) and disconnect the high pressure pipe (2b), expansion valve side.

Seal the connectors that have been disconnected using suitable plugs to prevent dampness and impurities from entering the system.

1. Undo the bolt (1a) fixing the pipe retaining bracket (1b) to the condenser and separate the pipe involved (1c).2. Disconnect the electrical connection for the linear sensor.

	Description	Connector
2	Linear sensor (for climate control)	See K120 LINEAR SENSOR FOR FANS

- Remove the pipe from the housing, releasing it from the retaining clips secured to the bodyshell. Refitting ( Removing ) - Check that the pipe is not damaged; if it is, replace it.- Replace the o-ring seals for the connectors using seals that are resistant to R134A refrigerant fluid.

Lubricate the connector threads using anti-freeze.

- Place the pipe in position securing it to the retaining clips fastened to the bodyshell. 1. Fasten the pipe (1a) to the pipe retaining bracket (1b) on the condenser and tighten the fixing bolt (1c) to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
Supply/return pipes (on condenser)	Bolt	M8	2.0	all versions

2. Disconnect the electrical connection for the linear sensor.

	Description	Connector
2	Linear sensor (for climate control)	See K120 LINEAR SENSOR FOR FANS

1. Connect the high pressure pipes (1a) and low pressure pipes (1b) to the expansion valve and tighten the nuts (1c) to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
Supply/return pipes (on expansion valve)	Nut	M10x1.25	3.5	all versions

    Op. 7210E10 R.R. FRONT BUMPER     Op. 7055B66 ENGINE COMPARTMENT DUST COVER IN RIGHT FRONT WHEEL ARCH - R.R. See Test 4410D22 BRACKET FIXING FRONT SUSPENSION CROSSMEMBER TO BODYSHELL (ONE), LEFT OR RIGHT - R.R.    Op. 4450B12 FRONT WHEELS (TWO) - R+R     Op. 1088B10 ENGINE COOLANT SUPPLY RESERVOIR - R.R. - Connect the negative battery terminal.

	Description	Connector
-	Battery	See A001 BATTERY

    Op. 0010T84 COOLANT FOR AIR CONDITIONING SYSTEM - DEHYDRATE AND REPRESSURIZE     Op. 0010T20 ENGINE COOLANT - CHANGE - Remove the vehicle from the lift.