The vehicle is equipped with two dipped beams in the main headlamps.To activate the dipped beam headlights, turn the special control wheel on the steering wheel interface left-hand lever.The wheel only has one position and this also activates side/number plate lights. The daylight lights (only switched on by the enablement signal with the key in the MAR position) are simultaneously deactivated. See E2010 SIDE LIGHTS / NO. PLATE LIGHTS The switching on of the dipped beam headlights is managed by the Body Computer.A special relay built into the Body Computer controls the activation of the dipped beam headlights via two lines protected by dedicated fuses.With the dipped beam headlights on, the simultaneous presence of the main beams command (stable position of the steering wheel interface lever) disables the dipped beam headlights. The subsequent deactivation of the control, with the dipped beam headlights control still activated, switches the dipped beams back on.The dipped beam headlights command function is activated by enablement signals from the ignition switch with the key inserted and turned to MAR, and from the steering wheel interface control.The dipped beam headlights control is active with the key turned to STOP for the Follow Me Home function.The Follow me home function allows the dipped headlights and the side lights to remain on even after the engine has been switched off (key in STOP position or removed) for a period of 30 seconds or multiples thereof allowing the area in front of the vehicle to be illuminated.This function can be activated by pulling the left-hand lever of the steering wheel interface towards the steering wheel (flash main beams), within two minutes of switching off the engine.This causes the front lights to come on for 30 seconds, a time which can be prolonged by 30 seconds each time the lever is activated, up to a maximum of 210 seconds.When this time is up the lights automatically switch off.When the lever is pulled the side lights warning light comes on in the instrument panel and a message appears on the display for the duration of the function. The warning light comes on when the stalk is pulled for the first time and stays lit until the function switches itself off automatically. Each time the lever is activated the time the lights are on increases.Keep the stalk pulled towards the steering wheel for more than 2 seconds in order to manually interrupt the function.The engagement of the dipped beam headlights enables the switching on of the rear fog lights using the special control in the centre panel. See E2031 REAR FOG LAMPS The activation of the dipped beam headlights also enables the adjustment of the orientation of the main headlights via the keys to the right of the instrument panel. See E3080 HEADLAMP AGLINMENT CORRECTOR If the dipped beam headlights were already activated during start-up (INT/A), they are temporarily excluded. When the key is next brought to the MAR position, the lights are activated once again.